The OS2 Shevtec controller is a flexible, fully compliant EN12101-10 control panel that can operate either as a stand-alone, networked, or multi-zoned system for both smoke and environmental ventilation applications.
With an 8 Amp output systems with a small number of smoke vents, or larger networked systems with high amperage smoke vents can be efficiently controlled by networking signals and reducing cable installation cost.
The system is OPEN PROTOCOL, accessible to any SE Controls authorised Partner or Licenced Installed within the national approved network to ensure the life safety system is correctly serviced and operational.
The SHEVTEC PSU control panel range is a fully compliant EN12101-10 solution to automate smoke vents (SHEV’s) with larger amperage draw or larger groups for both smoke and environmental applications. It can be networked over larger areas such as atria applications to reduce cable installation cost or built as larger modular control panels to operate SHEV’s from a single location.
Environmental ventilation is also facilitated via digital (volt free), analogue(0-10v) or Building Management System protocols, plus the system can operate as a stand-alone solution via the connection of remote sensors such as temperature, wind and rain.
The control panels can be manufactured to IP 55 for roof mounting to save on cable installation cost and save valuable plant room space. The system is OPEN PROTOCOL, accessible to any SE Controls authorised Partner or Licenced Installed within the national approved network to ensure the life safety system is correctly serviced and operational.
The MCP is a fully compliant EN12101-9 control point that integrates with OSLoop, OS2 Shevtec Controller and SHEVTEC PSU controls systems for fire fighting smoke shafts and lobby AOV’s, escape and fire fighting stairs, and atria smoke ventilation applications.
It provides both open and close/reset activation of smoke ventilators in addition to system activation and specific fault indication via a series of blink codes. The MCP is available in both surface mounted and recessed applications.
The rain sensor is utilised to close AOV’s that are opened for environmental ventilation as part of a combined smoke extraction and environmental control system. The system will open and override environmental status if a fire signal is received.
The wind speed sensor is utilised within a combined smoke and environmental controls system that automates AOV’s for smoke ventilation and control of indoor air quality. They are commonly required where the AOV’s are inclined within atria applications with greater exposure to wind load. Wind sensors are also utilised to close smoke ventilation AOV’s (SHEV’s) in atria applications when they are open on the windward side, allowing the SHEV’s on the leeward side to exhaust the smoke.
The temperature sensor is installed as part of a non-residential smoke ventilation system when the system is also utilised for environmental temperature control. Fire mode will always override environmental mode then return to environmental status once reset.